Skip to main content
Topic: 3Dlabprints Q-Trainer build (Read 2468 times) previous topic - next topic

3Dlabprints Q-Trainer build

Part 1: This is the first post of hopefully many as I work on my Q-Trainer. So far I have completed most of the fuselage and mounted the motor.

Re: 3Dlabprints Q-Trainer build

Reply #1
Looks really good.
I like the clear filament on it as well.

What flight controller set up are you going to use?

Re: 3Dlabprints Q-Trainer build

Reply #2
Thanks.

When you say "flight controller" you mean like a RC transmitter or a device to help keep the airplane stable?

Re: 3Dlabprints Q-Trainer build

Reply #3
Yeah,  what type RC transmitter /receiver set up will you use?

Re: 3Dlabprints Q-Trainer build

Reply #4
This is the gear. Flysky FS-TH9X Tx and the FS-R9B Rx.